Futaba Motakere

Futaba R2006GS Motaker 6-K 6J,8J,10J 2.4G S-FHSS,HV   Futaba R2006GF 2.4Ghz FHSS mottaker er ment for bruk sammen med 4YF, 3PL, 4PL og 6J sender.  S-HFSS modus kan kun brukes sammen med digitale servoer. Spesifikasjoner: Antall kanaler: 6 Spenning inn: 4,8-7,4V Mål: 43,1 x 25 x 8,8mm Vekt: 8,5g Rekkevidde: Ca 1000 meter Strømtrekk: 80mA NB! Passer kun til Futaba sendere på FHSS, ikke FASST.

Futaba R2008SB S.Bus 8-Channel S-FHSS Receiver Futaba 8CH mottaker for radioer med S-FHSS som Futaba 8J. Mottakeren er ikke kompatibel med FASST-systemet.   FEATURES: For aircraft models Dual Antenna Diversity High voltage operation (4.8 - 7.4V) Frequency hopping Spread Spectrum design S.Bus system output port and conventional system channel outputs, may also be used with conventional (non S.Bus) system servos   SPECS: Modes: S-FHSS or FHSS Voltage Input: 4.8V-7.4V battery or regulated output from ESC Capable of 4 channels only in FHSS mode Compatible Batteries: NiCd, NiMH, LiPo, LiIon or LiFe Dimensions: 0.98 x 1.69 x 0.55 in (24.9 x 42.8 x 14.0 mm) Weight: 0.34 oz (9.5 g)

Futaba R202GF 2K 2.4G S-FHSS Bil/Båt Motaker Futaba 2CH mottaker for radioer med S-FHSS . FHSS / S-FHSS 2.4GHz system 2-channels Power Requirements: 4.8-7.4V Size: 23 x 35 x 9 mm Weight: 6 g 

Futaba R202GF 3K 2.4G S-FHSS Bil/Båt Motaker Futaba 3CH mottaker for radioer med S-FHSS . System: 2.4GHz FHSS Channels: 3 Antenna: Single Size: 39 × 26 × 10 mm Weight: 8.0 g Voltage: 4.8 - 7.4V Frekvens: 2,4GHz Signalsystem: FHSS, S-FHSS Längd: 39 mm Bredd: 26 mm Höjd: 10 mm Vikt: 8 g Drivspänning: 4,8-7,4 V Strömförbrukning: 30 mA Kanaler: 3 Specialfunktioner: HV (High Voltage)

Futaba R2106GF S-FHSS Micro Motaker  6ch mikromottaker for Futaba 2.4G FHSS, Lett mottaker som tåler helt opp til 2S LiPo innspenning. PS: Ikke kompatibel med FASST-radioer. This is the R2006GS 2.4GHz SFHSS 6-Channel Receiverused with the Futaba 6J 6-Channel 2.4GH Aircraft Radio. FEATURES: High-voltage (4.8 - 7.4V) capability eliminates the need for aregulator when using a 2S 7.4V LiPo pack as a power sourceEasy-Link circuitry, frequency hopping, spread spectrum designDual Antenna Diversity INCLUDES: Futaba R2006GS 2.4GHz SFHSS 6-Channel Receiver REQUIRES: Binding to transmitter, installing in aircraft and connecting servos SPECS: Modes: FHSS or S-FHSS Voltage Input: 4.8V-7.4V Compatible Batteries: NiCd, NiMH, LiPo, LiIon & LiFe Dimensions: 0.98 x 1.70 x 0.35" (43.1 x 25 x 8.8mm) Weight: 0.29 oz (8.3 g) Current Drain: 80mA (@ no signal) 

Futaba R3008SB T-FHSS 8 kanals mottaker 8-kanals mottaker, kun kompatibel med sendere som har T-FHSS-modulasjon. Det er også mulig å bruke kanal 9 og 10 via S.Bus. In spite of its small size of only 47.3 x 24.9 x 14.3 mm and a weight of just 11 g the R3008SB receiver is a multi-talented device. It features an integral telemetry transmitter, and can send up to 32 telemetry data sets to the ground over a range of up to 1000 m. Naturally the receiver features eight PWM outputs for normal servos. Channel 8 is switchable to S.BUS(1) mode, enabling up to ten S.BUS(1) servos or other devices to be connected to this output. The switched channels 9 and 10 can only be accessed via the S.BUS 1 or 2 output, and require suitable S-BUS compatible devices / servos. Both S-BUS2 servos and sensors can be connected to the separate bi-directional S.BUS2 socket; up to 32 telemetry channels can be transmitted. The integral transmitter sends the telemetry data present at the S.BUS2 socket to the T-FHSS® transmitter, where the data are displayed on-screen or generated in audible form (speech, vibration alarm, sound or beeper). When the receiver is connected, data such as receiver battery voltage, external voltage (max. 70 V DC) and aerial signal strength, i.e. the essential telemetry data, are automatically transmitted to the ground. This receiver "only" works with the new telemetry-capable T-FHSS® transmitters. It is not compatible with FASST or FASSTest® or S-FHSS transmitters or these types of modulation. Specifications Channels: 10 Weight: 11g Antenna length: 14cm The R3008SB receiver features bi-directional communication with a T-FHSS Air-2.4GHz Futaba transmitter using the S.BUS2 port. Using the S.BUS2 port an impressive array of telemetry sensors may be utilized. It also includes both standard PWM output ports and S.BUS output ports. R3008SB Specifications: Applicable systems: Futaba T-FHSS Air-2.4GHz system transmitters T-FHSS Air-2.4GHz system/S.BUS2 and S.BUS port and 8 channels for conventional system receiver Dual antenna diversity Size: 24.9 x 47.3 x 14.3 mm Weight: 10.1 g Power requirement: 4.8V to 7.4V Battery F/S Voltage: It sets up with a transmitter Extra Voltage port: 0 ～ 70V DC * Be sure that when using ESCs regulated output the capacity of the ESC must meet your usage condition.

Futaba R304SB T-FHSS-mottaker - BULK En liten og lett 4-kanals T-FHSS 2,4 GHz-mottaker med telemetri (sensorer tilgjengelig separat og kobles til via S.BUS2-porten). Leveres uten forpakning og uten manual. T-FHSS 2,4 GHz (telemetri)-mottaker for T3PV, T4PM, T4PV, T4PLS, T4GRS, T4PX og T4PXR Ekstern antenne (200 mm lang) Størrelse: L35 x B23,3 x H8,5/12,5 mm Vekt: 6,6 g Strøm: 4,8-7,4V batterier (Voltage rekkevidde: 3,5-8,4V) Manual for nedlasting

Futaba R304SB-E 4K 4PLS 2.4G T-FHSS Bil/Båt Motaker med Internantenne Futaba 4CH mottaker for radioer med T-FHSS . A new small and light 4 channel T-FHSS 2.4GHz receiver with telemetry (sensors available separately and are connected through the S.BUS2 port). Made for the T4PLS, T4GRS & T4PX radios.   T-FHSS 2.4GHz (Telemetry) receiver for T4PLS, T4GRS & T4PX Internal antenna (for electric cars) Size: L35 x W23.3 x H8.5/12.5 mm Weight: 6 g Power: 4.8-7.4V batteries (Voltage range: 3.5-8.4V)

Futaba R404SBS-E - F-4G Telemetry 4ch for T10PX 4 kanals motaker for Elektro.  Only compatible with T10PX F-4G/F-4G SR Receiving frequency: 2.4GHz band Telemetry Receiver RF power output: 2.2 mW EIRP Power requirement: 3.7 V~7.4 V battery (Dry cell battery cannot be used.) System: F-4G system/S.BUS2 system Size: 25.5x20.7x10.6mm (includes a 30.5mm high antenna housing) Weight: 7.2g

Futaba R7006SB FASTest, FASST 2.4ghz 6 kanals Mottaker 6 kanals motaker med mulighet for utvidelse til 18 kanaler med S-bus2   Egenskaper FAASTest 2.4GHz (18ch / 12ch mode) FASST 2.4GHz (Multi-channels / 7ch mode) Dual Antenna Diversity High Voltage S.BUS2 S.BUS Plus 6 normal channels Spesifikasjoner Størrelse: 22,5 x 38,1 x 12,2 mm Vekt: 8,5 g Effektbehov: 3.7V to 7.4V (spenningsområde: 3.5 to 8.4V) The R7006SB receiver features bi-directional communication with a FASSTest Futaba transmitter using the S.BUS2 port. Using the S.BUS2 port an impressive array of telemetry sensors may be utilized. It also includes both standard PWM output ports (1-6ch) and S.BUS output ports. The R7006SB can also be switched to the FASST (Multi-ch/7-ch) System. 

Futaba R7008SB FASSTest, HV 2.4ghz 8 kanals Mottaker Futaba R7008SB Receiver The R7008SB receiver features bi-directional communication with a FASSTest Futaba transmitter using the S.Bus2 port. Using the S.Bus2 port an impressive array of telemetry sensors may be utilized. It also includes both standard PWM output ports and S.Bus output ports. FASSTest-2.4GHz Bidirectional Communication System S.BUS2 / S.BUS Port and 8 Channels for Conventional System Receiver R7008SB Specifications: FASSTest-2.4GHz System (18CH/12CH mode) S.BUS/S.BUS2 8-channels for conventional system (not using the USB channels) Dual Antenna Diversity Size: 24.9 x 47.3 x 14.3 mm Weight: 10.9 g Power Requirement: 3.7-7.4V Voltage Range: 3.5-8.4V Battery F/S Voltage: It sets up in the transmitter Extra voltage port: Optional External Voltage Telemetry cable and CA-RWIN-700 unit can be used FPEBB0141 (0-70VDC) 8CH mottaker for futabaradioer med FASSTest-tekonologi, eksempelvis 18MZ. Mottakeren har telemetri og man kan bruke to samtidig for å få totalt 16 kanaler tilgjengelig. FASSTest S.Bus 2 High Voltage SPECS: Receiving Frequency: 2.4GHz FASSTest system Power Requirement: 3,7-7,4V Current drain: 75mA Size: 0.98 x 1.9 x 0.56" (24.9 x 47.3 x 14.3mm) Weight: 0.38oz (10.9g) PS: Kan ikke brukes mot radioer med FASST eller FHSS-modulasjon. * Be sure that when using ESCs regulated output the capacity of the ESC must meet your usage condition.