Handlekurv


Handlekurven er tom

0,-

Dusty Motors ARM0011 Protection Cover for Kraton/Talion

Art.nr: 47228
På lager: 4

299,-

Produktet er midlertidig utsolgt. Dersom du ønsker å motta en epost når vi får det inn på lager kan du legge igjen epostadressen din i skjemaet under.

Dusty Motors ARM0011 Protection Cover for Kraton/Talion

Dusty Motors beskyttelsestrekk i svart for Arrma Kraton og Talion (opp til 2018).

Dusty Motors beskyttelsestrekk er laget for å holde innsiden av din radiostyrte bil så ren som mulig. Utrustet med glidelås for enkel tilgang til elektronikken.

This is a high quality, hand made, dust and water splash proof shroud, designated to fit a particular model. Shroud comes with a zipper, which allows to access the internals of a model i.e. connecting/disconnecting batteries and turning a model on/off without removing a shroud. While taking a break between the running stints the shroud can be unzipped to allow ESC and motor to cool quicker. Shroud is made from the highest quality materials. That is why it is strong, durable and efficient. The open area of a material is more than 50% of total shroud surface, so it ensures a very good airflow in order to keep the model electronics cool.
 

  • Before applying VELCRO® to the chassis, cut the tape to the necessary length and width. For example, to place VELCRO® tape on an old Slash 4×4 nerf bars, you must cut it in both directions: length and width.
  • Make sure that the surface of the chassis is extremely dry and clean before applying the VELCRO® tape. Dip a napkin in pure alcohol and clean the surface of the chassis. (Use vodka if you like, but for best results, do not drink the vodka during the process).
  • Let the VELCRO® tape adhere to the chassis for 24 hours before you use the shroud.
  • If its hot outside, leave the Dusty Motors? shroud unzipped to promote airflow and help keep the electronics cool. Even when bashing with a unzipped shroud, it will still keep out most of the dust and debris.
  • When its hot outside or if you have a car gearing set up thats capable of reaching the speed of light be smart when you bash. Dont let the temperature of the electronics get too hot. Take breaks between rides. Unzip the shroud and let the model cool to a normal temperature.
  • When bashing in winter, dont bring your model into a warm room without removing ice and snow from the shroud. Otherwise, the snow will melt and water may penetrate the shroud and get into your model electronics.
  • Do not drive under water. It is a CAR, not a submarine, and the Dusty Motors shroud is only made for cars. Our shrouds are good, but they cant be breathable and 100 percent waterproof at the same time. Physics just doesnt work that way. The splashes of water are OK, so dont be concerned if the shroud gets a bit damp.
  • Remember to take care of the shroud. Wash it by hand with warm, clean water. Let it air dry, do not put it in a dryer.

https://youtu.be/qNNSt-XJa98


https://www.dustymotors.com/

Kommentarer

Share |
Dusty Motors

Dusty Motors


Dusty Motors - Produsent av beskyttelsesprodukter for RC-biler

Relaterte produkter

  • Bilde av 1/8 KRATON 6S BLX 4WD
    5.995,-
  • Bilde av 1/8 TALION 6S BLX 4WD
    5.695,-